Main Sight Tool - Now comes with the 30 degree pusher block for Glock and HK sights. A must have for Gunsmiths and Armorers. The Sight Pro uses a unique clamping shoe design, plus 4 slide support pads and a white nylon spacer block to lock the slide in place while adjusting or replacing sights. Two cuts on the lower section of the tool allow you to lock it in a bench vise. Redesigned to make it easier to swap out the pusher blocks. Shoes do not come with Sight Tool.
Slide Shoe - Unique clamping shoes are firearm specific. These work with the MGW Sight Pro.
Safely moves fixed sights right or left in their dovetails without deforming slide or sight. Specifically designed for use with factory and aftermarket Tritium night sights, which are too fragile for the traditional hammer-and-punch sight installation method; works equally well with iron sights. Thumbscrew securely locks the slide so it’s fully supported in the rigid, machined aluminum body. Separate slots in the screw mechanism engage the sight and firmly, yet gently, concentrate screw force to loosen sights from even extremely tight dovetails. Hardened steel handle provides plenty of leverage, while self-lubricating, oil-impregnated Oilite® bronze bearings and extra-fine threads ensure smooth, precise movement. Beretta/Glock fit rear sights only. Glock Flat-Side fits aftermarket rear sights with straight, non-sloped sides for standard- and large-frame Glock pistols. SIG fits rear sights on all SIGs except SIG-PRO. Smith & Wesson M&P fits both and front and rear sights; will not fit Pro models with 5" barrel. Will not fit the Shield model. Smith & Wesson M&P Shield now fits 9,40, & 45 models. Springfield XD fits both front and rear sights on all XD models except front sight on 5" barrel Tactical model. These do not work on the front sights of Pro/Tactical or sub compact XD/XDM model front sights. Will not work on XD-S slides. 1911 will not work with most Kimber slide/sight combinations. Only works on rear sights. Not for installing or adjusting front sights. Sig fits P220, P225, P226, P228, P239 only. Does not fit Sig Pro series. Does not fit P220 Elite Shadow. Does not work on adjustable sights.
“GLOCK” is a federally registered trademark of Glock, Inc. and is one of many trademarks owned by Glock, Inc. or Glock Ges.m.b.H. Brownells is an independent dealer of parts and accessories for Glock® pistols, and is not affiliated with or endorsed by Glock, Inc. or Glock Ges.m.b.H. The use of Glock on this page is merely to advertise the sale of Glock parts or components. As indicated in the product descriptions, not all parts and accessories on this site are official Glock products.
SPECS: Aluminum body, anodized. Steel cross carriage bolt and thumbscrew, black oxide finish. Beretta/Glock - 4¾” (12.1cm) wide, 3” (7.6cm) high, ¾” (19mm) thick. Glock Flat Side - 4¾" (12.1cm) wide, 2½" (6.4cm) high, 1¼" (3.2cm) thick. SIG - 4¾” wide, 5” (12.7cm) high, 1” (2.5cm) thick. Smith & Wesson M&P and Springfield XD - 4¾” (12.1cm) wide, 3-5⁄8" (9.2cm) high, 1-5⁄8" (4.1cm) thick; fits front and rear sights. M&P will not fit Pro models with 5" barrel. 1911 will not work with most Kimber slide/sight combinations.