"Today, if you do not want to disappoint, Check price before the Price Up.Sight Pro Sight Mover Mgw You will not regret if check price." best price Sight Pro Sight Mover Mgw
Main Sight Tool - Now comes with the 30 degree pusher block for Glock and HK sights. A must have for Gunsmiths and Armorers. The Sight Pro uses a unique clamping shoe design, plus 4 slide support pads and a white nylon spacer block to lock the slide in place while adjusting or replacing sights. Two cuts on the lower section of the tool allow you to lock it in a bench vise. Redesigned to make it easier to swap out the pusher blocks. Shoes do not come with Sight Tool.
The tough nylon coating on these rods absolutely won’t scratch the delicate rifling of the finest match barrel and won’t peel off like many vinyl coatings do. Smooth turning, ball bearing handle. Supplied with Adapter for standard 8-32 male thread brushes and accessories (Except .17 and 20 caliber rods; they are 5-40 female). Plus, an extra-long Dewey Jag that takes a patch either wrapped-around, or over-the-end, and fits directly onto the rod’s male thread. 17C and 20C series rods do not include brush adapter. Use of breech or muzzle bore guide recommended.
SPECS: Handles are 1-1/8" (2.9cm) dia. x 2-7/8" (7.3cm) long. The number following the dash in the model number represents the rod length in inches, 1"=2.5cm. 17C rods fit .17 caliber 20C rods fit .20 cal-.22RF. 22C rods fit .22-.26 caliber 30C rods fit .27 caliber and up. 38C-12 fits .27 caliber and up handguns. Length is indicated by Factory part number suffix instead of just suffix number i.e. 11=11 inches etc.
Low-profile, flattop-mounted, polymer sights deploy instantly at the touch of a finger to provide backup sighting if a primary optic fails. Streamlined contours mean there’s nothing to snag on brush, sling, or other gear when folded. Spring-loaded ambidextrous release mechanism lets you hit the grooved tab on either side of the sight to deploy, and lock it in place. Hitting the same tabs retract the sight when you’re done. Uses less than 1" of MIL-STD 1913 Picatinny receiver rail space and locks securely in place with the included steel crossbolt. Provides the same height over bore as standard A2 iron sights. Windage-adjustable rear sight has two apertures: a large, .185" peep and a .070" peep. Designed for AR-type rifles and carbines, fits any weapon with Picatinny rails.
Reinforced, injection-molded polymer, Black, Dark Earth, or O.D. Green. Heights measured from top of rail to top of sight. Rear Sight - 1.5” (3.8cm) long deployed, 2.6” (6.8cm) long folded, 1.2” (3cm) wide, .5” (1.3cm) high folded, 1.6” (4cm) high extended. Large aperture, .185” (4.7mm) diameter. Small aperture, .070” (1.8mm) dia.